The scanner does nothing, types into the wrong box, or scans the wrong product. What do I check?

First scan a barcode into Windows Notepad: if digits appear there, the scanner is fine and the setting is in the till; if nothing appears, the problem is the scanner, its cable or its own settings.

Nothing happens at all

  1. Unplug the scanner and plug it into another USB port.
  2. Open Windows Notepad and scan a barcode. No digits: the scanner itself is at fault. Check the cable, or scan the “factory default” and “USB keyboard” codes in the scanner’s leaflet.
  3. Digits appear in Notepad but not in the till: go on below.

It beeps, but the till does not react

  • Open Hardware: is the simulator tile switched on? A real scanner still works with simulators, but check the Scanner card.
  • In the Scanner card, press Test: scan something and scan. Nothing received means the till does not see this scanner: remove it from the card and add it again with Learn USB scanner (scan now): see How do I set up a barcode scanner?.

It types into the wrong box

The scanner is seen as a keyboard, and the cursor was in another box. Teach the till the scanner with Learn USB scanner (scan now): a learned scanner is read directly and never types into a box.

The barcode is “not known” although the product exists

It adds the product twice

The scanner reads the same label twice in a row when held too long. Most scanners have a “same code delay” setting in their leaflet.

For: Cashier Manager Owner since version 1.0.0

Did this help?

Print this article · Contact support