Plug the drawer’s cable into the drawer socket of the receipt printer. The till opens it through the printer with a standard signal. If it stays closed, run Find the drawer setting: the till tries the common signals one by one and saves the one that opens your drawer.
Connect it
- Plug the drawer’s cable (a phone-style plug) into the socket marked for the drawer on the back of the receipt printer. Not into a phone or network socket.
- Set up the receipt printer first: see How do I set up the receipt printer?.
- Open Hardware and the Drawer card. The usual Type is the drawer through the printer.
- Press the test. If the drawer opens, you are done.
The drawer test
- Open Test hardware in Hardware and press Find the drawer setting.
- The till sends one signal and asks Did the drawer open?
- Answer Yes, or No to try the next signal, or Stop. There are eight candidates, a couple of seconds apart.
- On Yes, that setting is saved for this till.
A cashier can start the same test from the till: pressing Open drawer twice within 10 seconds offers it.
Settings by hand
Open command, Pin (0 = pin 2, 1 = pin 5), On time (x2 ms, default 25) and Off time (x2 ms, default 250) are the signal itself; your drawer’s leaflet may give them. The on time must be at most a quarter of the off time, or the drawer’s coil can overheat. A serial drawer and an OPOS drawer have their own kind. Drawer open when the sensor signal is high is for drawers that report whether they are open.
Who may open the drawer without a sale is set on the same card: see How do I decide who may open the cash drawer without a sale?.
For: Owner since version 1.0.8
Did this help?
Thank you. Your answer helps us improve the help.